Page 1 of 1
Would this work?
Posted: Mon Oct 24, 2005 1:51 pm
by Infernal Maveric
Would that set up work at all? I know the drwings are crude, but paint is the best I have. Any suggestions?
Posted: Mon Oct 24, 2005 5:21 pm
by saladtossser
it would, 3/4" bushings fit most bottles, the tyre valve should not be there, put is somewhere in pvc fittings.
Posted: Mon Oct 24, 2005 6:22 pm
by CS
First off the "tire valve" is called a schrader valve (just for future refrence). Second off scrap the pop bottle. Why? Because first off just spend a little extra money and make a PVC chamber. Plus screwing a schrader valve into such a thin materail is not safe. I dont know what it is but alot of people like making some part of there gun out of a pop bottle, nothing screams "WHITE TRASH!" as bad as this. So the morale of the story is safe up some money and make a PVC chamber. Your design will work though.
Posted: Mon Oct 24, 2005 7:54 pm
by boilingleadbath
You trying to get us sued, pimpmann?
Schraeder is a brand name, you know; tyre/tank valve is fine.
Posted: Tue Oct 25, 2005 3:12 am
by Cronic
Lol this is funny. But i would strongly suggent not making it out of a pop bottle you can use PVC insted (like boilingleadbath and pimpmann22 said)
And you can make your air container (I'm sure it's not called like that) from a steel pipe that you wheld on one end and wheld a tyre valve (Schraeder) to the other. It's safe and easy to make...
Posted: Tue Oct 25, 2005 3:23 am
by Infernal Maveric
Oh ok thanks guys. I Guess I'll try and invest a bit in a PVC chamber
