controlling an electric motor
- homedepotpro
- Specialist 4
- Posts: 443
- Joined: Sun Nov 26, 2006 1:00 am
what do you need it for, like what is it going to power.

a speed controller, a reciever and a transmitter. you can get it all at your local hobby shop, but it wont be cheap. maybe $250. chech ebay. if you need more detailed help let me know.
"physics, gravity, and law enforcement are the only things that prevent me from operating at my full potential" - not sure, but i like the quote
you know you are not an engineer if you have to remind yourself "left loosy righty tighty"
you know you are not an engineer if you have to remind yourself "left loosy righty tighty"
- jackssmirkingrevenge
- Five Star General
- Posts: 26216
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 576 times
- Been thanked: 347 times
hectmarr wrote:You have to make many weapons, because this field is long and short life
- shud_b_rite
- Specialist 2
- Posts: 290
- Joined: Tue Jan 30, 2007 7:10 pm
- Location: Auckland, New Zealand
What range of speed do you want. If you want a full range of speeds then you will need a speed controller, but that is going to be difficult to make or buy for a starter motor as it draws a lot of current.
If you want only 2 or 3 speeds then you could make your own resistors and wire them to SPDT switch. Note that this is probably not the best option, it it not efficient at all and produces a lot of heat which will probably melt your resistors.
If you want only 2 or 3 speeds then you could make your own resistors and wire them to SPDT switch. Note that this is probably not the best option, it it not efficient at all and produces a lot of heat which will probably melt your resistors.
Airbeds... so many different uses
- jimmy101
- Sergeant Major 2
- Posts: 3206
- Joined: Wed Mar 28, 2007 9:48 am
- Location: Greenwood, Indiana
- Has thanked: 6 times
- Been thanked: 18 times
- Contact:
Making a regulator that'll control a starter motor powered by a 12V automotive type battery is going to be really expensive. IIRC, a starter draws a couple hundred amps, not something your run of the mill electronics can handle.
Your best bet is to just use a low voltage switch to control a starter relay which in turn controls the power to the motor. You might be able to scrounge a starter relay for cheap from a junk yard. Or here is one for $6.50 rated at 225 amps.
Only two speeds; "full power" and "off".
Your best bet is to just use a low voltage switch to control a starter relay which in turn controls the power to the motor. You might be able to scrounge a starter relay for cheap from a junk yard. Or here is one for $6.50 rated at 225 amps.
Only two speeds; "full power" and "off".
