K i am dieing to build this but im only 16, parents would not exactly aprove. But for those of you who know what a model rocket it, i found a way to use them as Rocket propelled grenades. Its extremely cool, extremely dangerous but still... extremely cool. Now for those who do not know what a model rocket is or how they work i will explain so you better understand my idea in the end. Below is a picture of a model rocket engine. A model rocket engine consists of 4 things, the cardboard/paper wrapping it is encased in, clay to control steam of fire, and fuel/explosive powder and open space. When a model rocket engine is ignited, it burns through the larget section of its fuel, out the exaust nosel formed of clay on the bottom, eventually as it burns it will reach the the second region of clay, which has a small hole through it, the heat from the burning goes through the hole, igniting a second region of powder that acts an explosive charge. This charge is used to push a parachute out of the rocket in order to safely return it to earth from however many hundreds or thousands of feed it has gone into the air. Now what me and some guys used to do at a summer camp was we would rip apart about 10 engines, chop of the powder while removing the clay and wrapping, this would leave us with pure explosive powder. We would then take a large size engine either a D or an E the small engines that dont require linceses range from aa-E, aa being weakest. Now the next step, would be to assemble a very cheap model rocket maybe 5 dollars or so or 2 if scrap parts, we would put the engine in first, we would then just dump all of the poder into the rocket above the engine where the second charge goes off, after doing this we would tape the nosecone shut so that the only way for the blast to push something is by blowing up the rocket into nothing but tiny pieces. So basically, we fire, 10 seconds later HUGE BANG from 1000 feet in the air. My idea, if to use this concept of replica rocket propelled grenades and pvc piping or copper pipe, im thinking copper surrounded by pvc for extra blast and heat protection, to hold the rockets in and serve as a launch pad. All it takes to ignire a rocket is an igniter plug which can easily be fed into the tube with the rocket on it. The plug is just 2 wires and some thing on the tip of them, when an electric charge from 4 AA batteries is sent through it, it heats up to the point of firing the engine. If this was attached to the launcher, and the launcher was protected from the heat and had an exaust pipe on it for the fumes and heat pushing out of the engine, you could potentially make a fake yet real RPG launcher. Just aim, press the button, igniter burns, engine ignites, rocket goes flying almost perfectly at the target, once the engine burns through, target is, in theory, seriously damaged or obliterated.
PLZ NOTE I AM OF NO SORT A TERRORIST THIS IS SIMPLY A CONCEPT USED ONLY FOR FUN NOT TO BE AIMED AT ANY LIVING THING, EVER. SERIOUSLY DANGEROUS IF YOU DO TRY THIS MAKE SURE YOU KNOW WHAT YOU ARE DOING FIRST.
