Show us your pneumatic spud gun! Discuss pneumatic (compressed gas) powered potato guns and related accessories. Valve types, actuation, pipe, materials, fittings, compressors, safety, gas choices, and more.
-
jrrdw
- Moderator
- Posts: 6572
- Joined: Wed Nov 16, 2005 5:11 pm
- Location: Maryland
- Has thanked: 39 times
- Been thanked: 22 times
-
Contact:
Fri May 09, 2008 5:03 pm
Dremel out the tee to the half way point, use a short piece of pipe for a cylinder the piston can ride in.
-
psycix
- Sergeant Major 4
- Posts: 3684
- Joined: Mon Jun 25, 2007 7:12 am
- Location: The Netherlands
Sat May 10, 2008 6:15 am
jrrdw wrote:Dremel out the tee to the half way point, use a short piece of pipe for a cylinder the piston can ride in.
Ride? Id rather call it slide
But yes, that can do it.
-
MrCrowley
- Moderator
- Posts: 10078
- Joined: Fri Jun 23, 2006 10:42 pm
- Location: Auckland, New Zealand
- Been thanked: 3 times
Sat May 10, 2008 5:57 pm
Edit: Sorry wrong topic.
Anyway, i've done it in 5minutes with a holesaw, they cost a bit, but it's worth it. You can get sets for about $20 now.
-
jrrdw
- Moderator
- Posts: 6572
- Joined: Wed Nov 16, 2005 5:11 pm
- Location: Maryland
- Has thanked: 39 times
- Been thanked: 22 times
-
Contact:
Sat May 10, 2008 6:10 pm
no-limit wrote:Dremeling out the tee sounds like a very long and diffcult time.
It's harder to not go to deep then it is removing the plastic inside the tee.
