Take a dremel and grind them out. I see nothing that would affect the valve's strength by
removing the flow restrictions
Anyone modded a QEV for flow before?
-
MrCrowley
- Moderator
- Posts: 10078
- Joined: Fri Jun 23, 2006 10:42 pm
- Location: Auckland, New Zealand
- Been thanked: 3 times
Dremel wouldn't do the job except for a little sanding down. Had to use a drill, which was pretty dodgy because a few times it jumped and almost took a chunk off the seat/port.
So far so good, using a mirror to look in to the barrel port I think the diaphragm is flexing a little bit more but all seems well. I might take out the last two supports and see how that goes.
So far so good, using a mirror to look in to the barrel port I think the diaphragm is flexing a little bit more but all seems well. I might take out the last two supports and see how that goes.