Compressed air engine

[jor2daje]

I've built a few air engines, I used a wobbler engine design you have a piston and cylinder assembly that pivots on a flat surface, the piston has a flat that essentially seals with this flat surface. The cylinder has one hole in it that let's air in and out, and the flat surface has two, one for intake and one for exhaust, as the crank rotates the cylinder pivots and lines up with each hole accordingly. For stirling engines you should look at marble displacer types, they are incredibly cool and I think much more interesting to watch. The only tricky parts are the graphite piston and the geared flywheel.





If you want I'll grab a picture or two of my marble displacer engine too.

[jackssmirkingrevenge]

jor2daje, I enquired in the lathe thread and I'll enquire again, any chance of seeing this little beauty running?

[ramses]

http://en.wikipedia.org/wiki/Uniflow_steam_engine

http://en.wikipedia.org/wiki/File:Steph ... e_gear.jpg

http://en.wikipedia.org/wiki/Corliss_va ... s_valve_ge

[jor2daje]

Sorry jack must have missed that in the last thread
[youtube][/youtube]

[Gun Freak]

Beautiful engine, too bad I don't have a lathe
I've seen an engine like it but was made of wood. It is a good design. I think the type like I posted would be easier for me to construct, since I don't have a lathe or mill to make the flats. But I'm still deciding which to use.

For my stirling, I want to make an LTD and a candle one, but the marble displacer ones are interesting too. Makes a candle a bit more interesting

[jackssmirkingrevenge]

Sorry jack must have missed that in the last thread

No worries

Sexeh! and just 15 psi, nice

[Gun Freak]

Dang I need a Sherline

[jrrdw]

Here's one that I like.

[youtube][/youtube]

[Gun Freak]

Jrrdw I love that one! I just can't figure out how it works

[jor2daje]

It's the same principal as my engine, only with three cylinder assemblies.

[POLAND_SPUD]

It's the same principal as my engine, only with three cylinder assemblies

I have to join the discussion to point out that the simplest air engine can be built with an air cylinder and a 3 way valve


Though a 5 way valve would be even better

[jackssmirkingrevenge]

I have to join the discussion to point out that the simplest air engine can be built with an air cylinder and a 3 way valve

Yep, cylinder connected to a crankshaft, at the end of the stroke hits the 3 way valve and the cylinder retracts etc, I can see it.

[POLAND_SPUD]

I can see it

ohh btw now that you have a lathe you can build your own DCV valve... get a block of aluminium, drill a hole all the way through it then 3 perpendicular holes for ports and finally turn a spool

[jackssmirkingrevenge]

ohh btw now that you have a lathe you can build your own DCV valve...

I know, I know... but who needs it with a detent system? I have a 0.22" semi-auto on the drawing board with a blow-forward interrupter...

[jrrdw]

Jrrdw I love that one! I just can't figure out how it works

This will help you out if you haven't read it all ready.

Pneumatic Motor.