pcp rifle(video )

[saefroch]

Is it just me, or shouldn't the o-ring detent be more to the left in the diagram, so that they aren't simply propelled into the bolt?

[jackssmirkingrevenge]

Is it just me, or shouldn't the o-ring detent be more to the left in the diagram, so that they aren't simply propelled into the bolt?

The o-ring looks like it's there to seal the bolt, not act as a detent.

[Crna Legija]

you will be sine
But i´m try to make a hammer valve that take 1000 psi but easy enough to be opened by a relatively weak spring design/tip will be appreciated

that link wont work but it more funny so ill leave it

but you need:

[wyz2285]

The o-ring looks like it's there to seal the bolt, not act as a detent.

correct I have used a machined aluminium tube for detent, 5mm long, a bb fits perfectly inside, and with a little bit of humility/lub, air-tight seal 8)

[jazzman56]

For those having trouble finding BB's in Aus there is this website that ships everywhere as SLINGSHOT ammo is legal everywhere. You can get 750 4.5mm steel bb's for $12

http://www.outdoorswarehouse.com.au/cat ... red&page=2

Also how can i build a Hammer valve with common parts and limited resources e.g Bunnings??

Where can i get a barrel online for 4.5 mm steel bb's???

What's the best homemade pump to build with limited resources (again bunnings and online)??

Thanks jazzman

[Zeus]

that link wont work but it more funny so ill leave it

Works for me.

[Crna Legija]

Also how can i build a Hammer valve with common parts and limited resources e.g Bunnings??

For a 4.5mm gun, a blow gun will be fine.

What's the best homemade pump to build with limited resources (again bunnings and online)??

good pump how to. Should be able to get all the parts at bunnings, but i say get a fridge compressor.

i don't think you would be able to get the BBs in vic because slingshots aren't allowed

[jazzman56]

Crna Legija

Is there an actual how to for a easy hammer valve with common parts?

The slingshot handles and complete kit are illegal but the pellets are not in all states of Australia

Scroll down to the table
http://www.outdoorswarehouse.com.au/pr ... llets.html

[Crna Legija]

Crna Legija

Is there an actual how to for a easy hammer valve with common parts?

If you what a 4.5mm bore then all you need is a bow gun. it will have plenty flow for such small ammo.

[wyz2285]

I may make a how to about how to use a blowgun to make a hammer valve . Anybody wants it?

[Gun Freak]

Jazzman the blowgun in Crna's drawing is backwards.
Wyz I'm sure that would be very helpful to a lot of people.

[warhead052]

Wyz, please do. Make it as simple as possible though, so that people with basic tools such as drills and hack saws will be able to make it.

[wyz2285]

Don´t worry, I only have basic tools too
But drill and saw are needed, I didn´t use a dremel, but if you have one, it will help, as I consider my dremel as my best friend

[warhead052]

Haha, I was thinking about getting one of harbor freights knock offs just to see if I like it or not.

[cacob_jlarke]

okay, so I've been reading this forum for a few days now as I have been making my own blowgun valve air rifle, and I just want to ask, how did you make your suppressor?