mini maniac

[sniper hero]

this is my mini combustion
I made a while ago but it didn't work
today I discovered that the trick is to spray a little bit of axe in it and wait 6 seconds before closing the spray opening and then shoot
it shoots a small piece of paper through a whole room.
the barrel is 6mm
the pvc is 32mm OD

[bigbob12345]

Well that chamber is a bit overkill but it looks like a fun thing to mess around with.

[STHORNE]

well, what works best with minis is to spray your axe in there, then give it a quick blow/puff of air (right into the chamber), then quickly put the cap back on. It should only take you 2-3 seconds or so.

You should also see an increase in performance. Btw, try shooting nails with a bit of electrical tape at the end

[Carlman]

nice one mate!

with that chamber you can triple your barel and you would be gining performance, you could even quad it!

[TheTrooper]

Like Carlman said your chamber is a lot of overkill, but since you might not be able to extend your barrel its ok.

Whys the barrel so crooked

[sniper hero]

the barrel is crooked because the cap is thin and the barrel is not deep in the chamber.
I will make a better mini soon