Muzzle loading

The standard way of doing things, because it is the cheapest and easiest to make; in fact, it is not possible to make a launcher that cannot be muzzle-loaded.

To muzzle-load a spudgun:

• Get a (strait) stick, and preferably mark it where it is flush with the muzzle when the pushing end of it is at the desired projectile depth.
• Cut your projectile to size, by either pushing your projectile over your muzzle knife or your seperate spud cutter. Paring knifes are not recomended.
• Ram that projectile home. Firm, steady pressure works best. If you cannont get the projectile go down, you may need to scratch it; this is done to allow the air to leak past.

Some design their launchers to be easier to muzzle load by making a small (like 1/16") vent hole at the base of their barrel for air to excape. This air would otherwise prevent the nearly airtight ammo from being rammed down there. Some, however, prefer to install a small valve of sorts. This prevents air or hot combustion gasses from shooting out and decreasing preformance and/or burning the operator.

It is recomended that you sharpen your muzzle if you are planing apon shooting produce. Such a modification is called a "muzzle knife". If you do not feel safe having a cutter on the end of your gun, you can instead keep your spud cutter as a seperate instrement.