Gets some PVC pipe, a couple elbows and Ts and make a Miniature marshmallow blowgun.
from here.another link
First post and want do you think of my designs?
-
jimmy101
- Sergeant Major 2
- Posts: 3206
- Joined: Wed Mar 28, 2007 9:48 am
- Location: Greenwood, Indiana
- Has thanked: 6 times
- Been thanked: 18 times
- Contact:
Hey, a 4 year old is the perfect age to start spudding...
Gets some PVC pipe, a couple elbows and Ts and make a Miniature marshmallow blowgun.
from here.
another link
Gets some PVC pipe, a couple elbows and Ts and make a Miniature marshmallow blowgun.
from here.another link
-
Jeeperforlife
- Specialist
- Posts: 108
- Joined: Tue Jan 15, 2008 4:51 pm
The reason for keeping it simple is I work 6 days a week, have a wife and 2 kids. Not a lot of time for fabricating. However I know I would regret not doing it the best I could. Hmmm, I will start researching piston valves, I want as much power as I can get in a small package.
If you have sugestions post up here. when it comes time for building I will start anoughter thread.
Marcus
If you have sugestions post up here. when it comes time for building I will start anoughter thread.
Marcus
You don't happen to be Marcus Weck? cause if you are HOLY SHIT!!!!
-
Jeeperforlife
- Specialist
- Posts: 108
- Joined: Tue Jan 15, 2008 4:51 pm
don't think so.pizlo wrote:You don't happen to be Marcus Weck? cause if you are HOLY crap!!!!
-
Jeeperforlife
- Specialist
- Posts: 108
- Joined: Tue Jan 15, 2008 4:51 pm
Allrite after looking around I think I will go with a burst disk with a ball valve. this should be simple yet better flowing. I punched in the info in to GGDT I got a maximum speed of 417 FT per sec. I was hoping for better. any ideas?
