First Poly Piston Gun - Black Gold.
This is my latest creation. I decided to make a piston valve using entirely out of poly pipe fittings. I think the gun itself turned out quite well. I wanted to make something that could be pulled apart and stuck into a bag, but I also wanted to be able to change the barrel/chamber of the gun. It's just about finished. I had a blowgun actuating it and it worked quite well, but I want to add a modded sprinker valve and add a small stock.
Anyway, enjoy .
(It still needs a bit of a clean up...)
Anyway, enjoy .
(It still needs a bit of a clean up...)
Looks really good mitchza. The new barrel(hopefully longer) will improve performance a lot. What pressures do you run it at?
People call me ThunderChunks...I dont even know why...
Got a Gamertag?, mines KillerHedgeHog3, add me
Got a Gamertag?, mines KillerHedgeHog3, add me
- battlemonkey
- Specialist
- Posts: 137
- Joined: Sat Sep 22, 2007 3:42 pm
Good looking, nice simple gun. What are you using for ammo
- jackssmirkingrevenge
- Five Star General
- Posts: 26179
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 543 times
- Been thanked: 321 times
Very nice, and at elevated pressures the performance should really be something, los damage pics por favor!
hectmarr wrote:You have to make many weapons, because this field is long and short life
- Carlman
- Staff Sergeant 2
- Posts: 1618
- Joined: Sat Nov 24, 2007 1:18 am
- Location: Western Australia
- Been thanked: 2 times
lol ah k getcha nowspudfarm wrote:ohh you don't ynderstand
if you use just 50psi you can use it just like a normal paintball gun
but if you want to obliterate something you go high
Aussie spudders unite!!
500psi?! Damn... I didn't know this stuff was rated that high. I saw a sticker on a piece of poly (not the one I got) but it said only 1750kpa I mean that's bloody terrible...
I've got a coax bb gun that uses a 600mm piece of 1/2'' poly, and it's holding perfectly at 300psi so I'm not sure
Cheers for all the comment's lad's
I've got a coax bb gun that uses a 600mm piece of 1/2'' poly, and it's holding perfectly at 300psi so I'm not sure
Cheers for all the comment's lad's