My next project requires me to sleeve a PVC pipe inside a length of square PVC structural tubing.
For the initial connection, I used medium thickness PVC solvent to bond the pipe to the square tube at all four lines of contact. I did this about 3 hours ago.
The next step requires that I fill in the corners with epoxy to form a solid piece. My concern was that the vapors still coming from the PVC solvent might interfere with the epoxy curing process. The main ingredient in PVC solvent is acetone, and I've read that acetone can break down epoxy resin.
Any opinions on whether I should proceed with injecting the epoxy now or wait a while first?
Epoxy after PVC gluing?
-
PVC Arsenal 17
- Staff Sergeant 3
- Posts: 1762
- Joined: Mon Mar 27, 2006 4:18 pm
- Location: United States
- Attachments
-
- Hopefully this clears up what I'm trying to do. The gray circle is the PVC pipe. The black square is the square PVC tube. The lighter gray between them is the epoxy. (ignore the last step)
- gif.gif (17.5 KiB) Viewed 1064 times
Last edited by PVC Arsenal 17 on Thu Jul 02, 2009 2:08 pm, edited 1 time in total.
-
jackssmirkingrevenge
- Five Star General
- Posts: 26216
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 576 times
- Been thanked: 347 times
Acetone is highly volatile, I doubt that after 3 hours at room temperature there are any significant fumes left.
-
PVC Arsenal 17
- Staff Sergeant 3
- Posts: 1762
- Joined: Mon Mar 27, 2006 4:18 pm
- Location: United States
It still smells rather strong. You wouldn't worry about that?
-
jackssmirkingrevenge
- Five Star General
- Posts: 26216
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 576 times
- Been thanked: 347 times
Unless you actually poured acetone into the resin mixture, not at all.
-
PVC Arsenal 17
- Staff Sergeant 3
- Posts: 1762
- Joined: Mon Mar 27, 2006 4:18 pm
- Location: United States
I'll start then. Thanks for the help.