Bernzomatic Torch
Another type of fuel meter is simply a needle valve and a low range pressure gauge. The needle valve can be the valve and very small outlet hole in a typical Bernzomatic torch head.
The needle valve is plumbed to the chamber as is the low pressure gauge. To protect the torch and gauge it is a good idea to plumb both through a single small ball valve. To use, the ball valve is opened. Then the needle valve is opened a small amount. When the pressure in the chamber has risen 4% the two valves are closed. Assuming an atmospheric pressure of 14.7 PSI, adding 4% propane will raise the pressure in the chamber by 0.59 PSIG. Since the pressure rise is small, standard 120 or 250 PSIG gauges won't work for this type of meter.
A possible replacement for a low pressure range gauge is a "U-tube manometer". In this type of pressure gauge the pressure is related to the difference in height of the two columns of liquid. If the U-tube is filled with water, then a 1" difference in height represents a 0.0361 PSI difference in pressure. So, 0.59 PSI would be a 16.3" height difference for the two water columns.
Measuring propane seems easy enough, as the article says you need 16.3" height difference.
Has any one used a U tube manometer to fuel a hybrid? I haven't found anything searching Google images, using the parameter site:spudfiles.com, or using the search here on spudfiles.
And the wild idear...
If you wanted to measure 45 psi in a 1:1 ratio manometer it would need to be very tall. So I was thinking what if the side exposed to the atomsphere was a 4" pipe, and compressed air side was 1/8" ID tubing. With that big difference in ratio will that destroy the accuracy? Basically should I just use a pressure gauge like a regular person? Would it even work as I intend?
You could try to pull this off just for kicks, but a normal pressure gauge will have higher accuracy, occupy less space, be more durable (not subject to orientation), and probably also cost less.
My misconception, still interesting though: 5 ignorant f###ing hours later...
Variations on the U-Tube Manometer
The differential pressure is always the difference in column heights, regardless of the size or shape of the tubes. As shown in Figure 6A, the legs of both manometers are open to the atmosphere and the indicating fluids are at the same level. Connecting the same pressure to the left leg of each manometer causes its level to lower. Because of the variation in volume in the manometer legs, the fluid in each column moves a different distance. However, the difference between the fluid levels in both manometers is identical (see Figure 6B).
Well the plan is a liquid column (manometer) for propane, and air regulator for air. Got a hybrid burst disk cartridge I need to test out. Thinking of chaining several together with air hose and pinching off in between each one so they can be fueled all at once, then later sealed off from each other for firing.
Poland, issue of cost. I don't have anything like the stuff your talking about lying around. I do have all the junk handy for a manometer lying around and portability isn't and issue.
Remember that blood pressure is measured in MM Hg. Don't mix the units. Mg is considerably heavier than water. This is not mixing apples and oranges, it it mixing water and Mercury.
uhmm dude I know that - the reason I posted it here is not because I found something about 'mms of water' somewhere in the text but because he is looking for a a cheap and accurate gauge to measure pressure
Accurate gauges in this range (0-10psi or so) are usually very expensive but blood pressure gauges are dirt cheap