.22 revolver

[trae08]

ok i was walking around in a flea market and found a box of these by a trash can theres about 400 of them an i dont have the right kinda ramset so i was wondering if anyone here could help figure a way to set up a revolver that would spin them as i shoot.

thats all i need is a revolver setup i got the barrell an stuff

[judgment_arms]

Your not planning on making a firearm are you? What the heck are those anyway?

[noname]

I think he's thinking of some kind of air powered BB revolver or something, but I'm not too sure...

[PVC Arsenal 17]

Look like .22 blanks...

[iknowmy3tables]

maybe its an pellet gun clip, or speedloader for a revolver

[judgment_arms]

Ohh… I’ll bet that’s a speed loader for a .22cal revolver.

[trae08]

those are .22 blanks but there for a ramset..



see thats the gun those disks go to.. see the disk in the back of the gun.. the guns are like 200-400 bucks an i dont need one anyway..

no not a fire arm i just want to make a cheap little system to fire of these blanks like on 4th july or whatever

edit: those guns shoot nails into concrete and steel plates and stuff

[PVC Arsenal 17]

I was just thinking that! I got back from a minute Home Depot a minute ago and I was looking at some ramsets. You're right...

[trae08]

yep of course im right.. it wont really matter if i get a design for a few days like thursday... thats when i get on a plane an go back home i dunno if i can get these on a plane

[judgment_arms]

Of course you can get them on a plane, duck tape them to your head than put on a wig, when you go through the metal detector just tell them you got a plate in your head! No don’t because if you get caught you’ll be in big trouble, and I’d probably end up in the same predicament.

[Killjoy]

Why don't you just ship it to were your going? Oh you could just hide them in you ass and claim you have a bullet lodged in one of your butt cheeks when the metal detector goes off.

[iknowmy3tables]

dough I didnt think of a ram set you can always buy them at the store, but how the heck can you build a revolver, one of the reasons it took a while for the revolver to be invented is because machining technology wasn't good enough. how good are you at machining (metal)? if you're good you could make a pepper box, if your an extremly good expert then you could make a revlolver. if not than you got to have a prebuilt gun or ramset gun[/i]

[trae08]

i have a ramset gun just not the one that takes the quick load disks..

im thinking about just building a fire one day an throwing them all in there or somthing along the lines of that

[Pete Zaria]

It probably classifies as "solid propellants" and thus can't be discussed here, but I'm just thinking, if those .22 blank cartridges can drive a nail into concrete, they could probably propel a marble quite well Building a single-shot, .22-blank cartridge-fed marble gun wouldn't be that hard. Chamber that takes a cartridge in the back, barrel, hammer/trigger setup... done.

Peace,
Pete Zara.

[trae08]

well i dont think it works quite the way you think it does... the blanks itself dosnt propel the nail the blank goes off pushing a heavy steel piston against the nail "ramming" it into the concrete or steel.

i think thats about how it works and it be hard to make one to shoot a marble with somthing strong enough to stop the piston thats launching the marble be made out of pvc... and i dont feel like nor do i know how to machine anything to do that out of metal...