Now I have an order for a gun with a golfball barrel.A 150cm 50mm barrel 40mm barrel in an over under configuration.
Now thats out of the way.The valve is a 50mm/2" sprinkler valve which the person ordering wants to be launched with a simple squeeze of a trigger like a blow gun,but I was wondering if a modded blowgun would work very well,well actually I know there is much better ways of exhausting but I do not want to add a 25mm or 20mm sprinkler valve on top of the 50mm valve which doesn't look very good which is important with orders like this.
Just wondering what performance I would get out of this valve.Anyone that has modded one of these valves can provide some information it would be great.
Thanks for your time.
50mm/2" sprinkler venting.
- rna_duelers
- Staff Sergeant 3
- Posts: 1739
- Joined: Mon Sep 26, 2005 7:07 am
- Location: G-land Australia

- super spuder
- Corporal
- Posts: 558
- Joined: Fri Apr 06, 2007 9:05 pm
- Location: Ontario Canada


- rna_duelers
- Staff Sergeant 3
- Posts: 1739
- Joined: Mon Sep 26, 2005 7:07 am
- Location: G-land Australia
Well I do a little here and there,its mainly from word getting around.I get calls from people friends asking could I get a golball gun made or can you moddify me a Sprinkler valve etc.I didn't even plan to get into buisness but it happend.
I am going to have a 1/4 ball valve then the blow gun attached to it,so if more performance then remove the blowgun and use the ballvalve.
I am going to have a 1/4 ball valve then the blow gun attached to it,so if more performance then remove the blowgun and use the ballvalve.
