GGDT too optimistic?

Cannons powered by pneumatic pressure (compressed gas) using a valve or other release.
User avatar
JDP12
Staff Sergeant 5
Staff Sergeant 5
Posts: 1943
Joined: Fri Mar 30, 2007 8:34 pm

Hey all- I've been runnin GGDT simulations to try and simulate the paintball launcher, and am wondering if its too optimistic.

For some reason, i can't upload a picture... So here are all the stats,

Pressure 110
Outer D- 1.25
ID-0
Length-3
Barrel Seal
# of valves- 1
Flow coef-20
Seat-.78
Dead Volume-2
Piston Diam-1.25
Piston mass- 1oz
Vent Diam- .2
Pilot volume- 3
Bore-1.5
Length-7
Friction-.5psi
Mass- 2 OUNCES
Diameter-1.5
Initial position-0


It tells me i should get 99 ft/s and ~200 feet. Now this is fine for 2 ounce paintball grenades, but it seems way to optimistic for such a small chamber and low pressure...

What do you think???
User avatar
jackssmirkingrevenge
Five Star General
Five Star General
Posts: 26219
Joined: Thu Mar 15, 2007 11:28 pm
Has thanked: 582 times
Been thanked: 348 times

ilovetoblowthingsup wrote:It tells me i should get 99 ft/s and ~200 feet. Now this is fine for 2 ounce paintball grenades, but it seems way to optimistic for such a small chamber and low pressure...
You do have a long barrel and efficient valve to compensate for this though, at what launch angle was the 200 foot range calculated?
User avatar
JDP12
Staff Sergeant 5
Staff Sergeant 5
Posts: 1943
Joined: Fri Mar 30, 2007 8:34 pm

i did the calculate max range.... it was about 44 degrees

oh that's 7 inches by the way not 7 feet...hoping that was obvious..
User avatar
jackssmirkingrevenge
Five Star General
Five Star General
Posts: 26219
Joined: Thu Mar 15, 2007 11:28 pm
Has thanked: 582 times
Been thanked: 348 times

ilovetoblowthingsup wrote:hoping that was obvious..
Not as obvious as you thought :roll: but still, if it's going at 99 feet per second and launched at around 45 degrees, why not, as long as there's a favourable wind :)
User avatar
JDP12
Staff Sergeant 5
Staff Sergeant 5
Posts: 1943
Joined: Fri Mar 30, 2007 8:34 pm

hahahaahah....

it just seems like way too good for a volume of 3.5 cubic inches.

Guess I'm just stupid....

First chamber will be out of steel... because I can't wait for PVC to dry.... then after that it will be all PVC... assuming it is successful of course
Post Reply

Create an account or sign in to join the discussion

You need to be a member in order to post a reply

Create an account

Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute

Register

Sign in

  • Similar Topics
    Replies
    Views
    Last post