Paintball sniper

Moggle NZ · Wed Jan 25, 2012 3:07 pm

just a picture of the setup i might use just wondernig what i can in pvove on such as
metirals
airflow
just any thing

when u pull the bolt back the ball valve will open
and close when u push formards so u can have muliple shots

wh

Wed Jan 25, 2012 5:17 pm

Looks like your air will be restricted. That's good for repeated shooting but bad for power.

Gun Freak · Wed Jan 25, 2012 6:40 pm

Not a very practical design. There are easier ways to do it. Why a hammer valve and a ball valve?

Moggle NZ · Wed Jan 25, 2012 10:24 pm

that is why i posted it asking for halp then u just tell me whats bad not tell me what i can do to impove it

Gun Freak · Wed Jan 25, 2012 10:32 pm

1. Too much dead space

2. Bolt is overly complex

3. Make the air chamber one part (not two with a ball valve)

I would like to say though that the actual valve part looks doable with a little creativity. But, what pressure are you going to use? It will take a lot to get paintballs flying.

Moggle NZ · Wed Jan 25, 2012 10:39 pm

ok thanks gun freak i was thinking instead of a valve useing a solenoid valve is
15mm an ok size
or shud i opt for the bigger 25mm
i would prefur the smaller 1 for look reasons only

Gun Freak · Wed Jan 25, 2012 11:03 pm

I'm no sure you can get multi-shot on a ssolenoid valve... Have you given thought to a three-way valve?

Moggle NZ · Wed Jan 25, 2012 11:22 pm

you can ive seen it done b4

Moggle NZ · Fri Jan 27, 2012 1:16 am

is a 15 mm solenoid valve an ok size for this gun?

Paintball sniper

Donating Members