Were can I find a small pilot valve that I can use to trigger my QEV.
I want it to be able to work at 300 psi (20bars) pressure.
The current valve I´m using is a simple ball valve, witch I think is to big and it doesnt feel as a trigger.
pilot valve for 300 psi?
check ebay or mcmasters
personally id say go with a pneumatic relief valve, they are aluminum and will launch golf balls out of sight in seconds!and with these valves its already piloted!
these valves im talking about are inch and half
personally id say go with a pneumatic relief valve, they are aluminum and will launch golf balls out of sight in seconds!and with these valves its already piloted!
these valves im talking about are inch and half
Last edited by jsefcik on Sun Oct 21, 2012 8:24 pm, edited 1 time in total.
-
PVC Arsenal 17
- Staff Sergeant 3
- Posts: 1762
- Joined: Mon Mar 27, 2006 4:18 pm
- Location: United States
Is this gun connected to a constant air source? If so, the MJVO-3 has been proven at those pressures. A slide valve is always good too.
If you have a "fill here and shoot over there" setup then you can use a pistol-grip blowgun for that trigger feel. What size QEV is this? A good modded blowgun can handle a 3/4" QEV with no trouble.
If you have a "fill here and shoot over there" setup then you can use a pistol-grip blowgun for that trigger feel. What size QEV is this? A good modded blowgun can handle a 3/4" QEV with no trouble.
-
GustavssonB
- Private
- Posts: 19
- Joined: Fri Aug 03, 2012 10:37 am
It's a one shot Gun, i want a simple blow gun, but in Sweden i can only find blow Guns that is pressure rated to 10 bar:/
-
jackssmirkingrevenge
- Five Star General
- Posts: 26216
- Joined: Thu Mar 15, 2007 11:28 pm
- Has thanked: 576 times
- Been thanked: 347 times
they usually work to 30 bars thoughGustavssonB wrote:in Sweden i can only find blow Guns that is pressure rated to 10 bar:/
http://www.spudfiles.com/forums/micro-b ... 18270.html
hectmarr wrote:You have to make many weapons, because this field is long and short life