ok, well i have a 80mm tee(3") for a piston housing and i have no way of attaching my 80mm end cap to the back coz no plumbing stores sell the right parts.i need an idea of what to use to attatch them.btw the middle of the tee is 80mm but branches out to 90mm for some reason.the best idea i could think of to attatch the two is using a piece of 80mm pressure pipe to go inside the tee and attach the end cap on that, but no one sells 80mm pressure pipe.
another problem is i cant find a 100mm(4")-80mm(3") pressure pipe reducer and i cant attach the chamber to the 80mm tee?
any ideas?btw ive tried using rubber couplers coz you can tighten them but none fit.
EDIT:the mods edited my original title so i took the first sentance out which made no sence with a different title
