Featuring:
Ghetto Breech
Awesome Barrel Support
(with permission) "Fish Killer" trigger setup
This is my first project that I've put a lot of work into smaller detail into, such as an O-ringed ghetto breech, carefully measured barrel support, etc etc.
How good is it? Well, I don't know. I'm having problems with getting the qev to seal. My dad broke our 12v car tire pump, and it doesn't like my bike pump. When I stop pumping, air slowly leaks out the barrel. I'm thinking of re-telfon taping the brass bushing. It can still pilot when I open the blowgun though...
Enough of my rambling, here's some pics-
The whole thing (I hope no one is offended I'm standing on a China flag


Trigger setup - Nasty primer stain if from when I had to pull the fitting back out because it was too low for the barrel support. It fit dry-fitted though...stupid solvents. On the top is a mini pressure gauge, on the bottom is a schrader.

View down the barrel

Breech open

Well? Waddaya think? I know it needs a paintjob...